SP160 – Single Profile Machine

System Specification
Machine Name SP160
Products Wall Panels / Roof Trusses / Webbed floor Joists
Walls Any size Wall panels between 60mm & 150mm
Floors Any size Webbed Joist between 60mm & 150mm
Trusses Any size Truss between 60mm & 150mm
Profile Section Any size between 60mm & 150mm
Punching Units
Dimples Multiple Stud and Plate Dimples for accurate and fast connections
Service Holes For water and electrical services
Web Notch Removes the web of the profile so that studs can pass through for noggins
Lip Notch Removes the lip of the C plates so that studs  can be connected
Chamfer Removes the corners of the studs so that it can be used as bracing in walls and webs for roof trusses
Anchor Hole 13 mm hole is used for anchoring connections as well as general connections
Cut-off Pre-cut Part/Full Cut Guillotine
Printer Dynamic Inkjet Labelling
Material Grade S350-S550
Material Type Galvanize Steel coils
Material Gauge 0.6 mm-1.6 mm
Number of Machines 1
Production rate (m/hr)
Wall Panels 250-900 m/hr (depending on the design)
Roof Trusses 250-500 m/hr (depending on the design)
Webbed Joists 200-400 m/hr (depending on the design)
Products C&U Profiles (C profiles for plates and noggins are also possible)
Usage Residential dwellings or commercial buildings, dormitories, workers accomodations, hospital, university
buildings